# Wheel Chocks Buying Guide: How to Choose Wheel Chocks for Detailing Work

Learn how to choose wheel chocks for detailing work: match chock size to vehicle weight, check the base grip, pair chocks with the parking brake and store them well.

A wheel chocks buying guide for detailing work starts with one rule: the chock must match the vehicle and the ground it sits on. Wheel chocks are wedge-shaped blocks placed against a tire so a vehicle cannot roll while you work around it. Choosing them well means checking the size, the weight rating, the base grip and how you will store them between jobs. 

## Match chock size to the tire 

Chock size should follow the tire and the gap under it, not the price tag. A wedge chock needs to sit against the tread with its face touching the tire and its base flat on the ground. A chock that is too small can slide under the tire, while one that is too tall can miss the contact point. Measure the tire and the floor gap before you buy, and check the chock height against both. 

## Read the vehicle weight rating 

The vehicle weight rating on a chock tells you the load it is built to hold on a slope. Compare that rating with the loaded weight of the vehicle you detail, including water tanks and equipment in a van. Rubber wheel chocks and solid wedge chocks carry ratings printed by the maker, and the rating applies to the pair or the single chock as stated. A chock used beyond its rating can deform or slide, so treat the figure as a limit, not a target. 

## Grip, brake and storage habits 

A non-slip base keeps a chock from skating on a slick shop floor or wet driveway. Set the parking brake and place chocks on the downhill side before you raise a vehicle or work near a wheel. Chocks and ramps serve different jobs, because a ramp lifts a wheel while a chock only blocks it, so do not use one in place of the other. Store wheel chocks clean and dry in a fixed spot in your kit, and wipe off road grit so the base grip stays true. 

## Questions about choosing wheel chocks 

### How do I know which chock size to buy? 

Chock size depends on the tire diameter and the height of the gap under the tire. Pick a wedge that touches the tread and rests flat on the ground at the same time. A chock that is too short can pass under the tire, and one that is too tall may not meet the tread. Measure both before ordering. 

### Do I still need wheel chocks if I set the parking brake? 

Yes, wheel chocks add a physical block that the parking brake cannot provide on a slope or a slick surface. The parking brake holds through the brake system, while a chock blocks the tire itself. Use both together when you work near a wheel or raise a vehicle. Place the chock on the downhill side of the tire. 

### What is the difference between wheel chocks and ramps? 

Wheel chocks block a tire from rolling, while ramps lift a wheel off the ground for access underneath. A chock is a wedge placed against the tread, and a ramp is a raised incline the tire climbs. Use ramps when you need clearance and chocks to stop movement. Never treat a chock as a lifting device. 

### How should I store wheel chocks between detailing jobs? 

Wheel chocks store well clean, dry and in one fixed place in your equipment kit. Wipe off dirt and road grit after use so the non-slip base keeps its grip. Keep rubber chocks out of direct sun for long periods to limit cracking. A fixed storage spot saves time when you set up the next vehicle.
