# Process Risk Scoring: How to Score and Rank Process Risks

Learn how process risk scoring turns likelihood and severity into a clear risk level ranking, so you can set risk priority and act on the right steps first.

Process risk scoring gives each step in a workflow a number by combining how likely a failure is with how much harm it causes. You score each task on a defined scale, multiply likelihood by impact, then use the result to build a risk level ranking. This page explains the calculation, the scoring scale and the matrix behind it, and how a pre-job risk rating helps you decide what to control before work starts. 

## Building the likelihood and severity scale 

A scoring scale defines each level in words so two people rate the same task the same way. Write short descriptions for each likelihood step and each severity step, such as a scratch that buffs out versus damage to paint or a person. Keep the number of steps small enough to remember and match every step to a plain meaning. The scale matters more than the numbers, because vague levels produce scores nobody trusts. 

## The risk score calculation 

The risk score calculation multiplies likelihood and severity to give one number per task. A task rated high on both factors lands far above a task that is high on only one, which is how the multiplication separates real trouble from minor slips. The risk score matrix lays these products out in a grid so anyone can read the level at a glance. Record the two factors beside the score, because the product alone hides which one drives the risk. 

## Ranking risks and setting priority 

Risk ranking means sorting the scored tasks from highest to lowest and deciding where controls go first. Risk priority follows the score, but also the cost of the control and the chance of catching a failure early. A pre-job risk rating applies the same logic to a single upcoming job, flagging the steps that need extra care or a second pair of hands. Review the ranking whenever the workflow or equipment changes. 

## Questions about process risk scoring 

### What is process risk scoring in a detailing workflow? 

Process risk scoring is a way to put a number on each step of a workflow so you can compare them. You rate how likely a failure is and how severe its effect would be, then multiply the two. The result lets you rank steps and decide which controls to put in place first. It works for any process, including wash, correction and coating stages. 

### What is a pre-job risk rating? 

A pre-job risk rating is a quick score of the risks on one specific job before you begin. You note the steps with elevated likelihood or severity, such as a delicate finish or tight access, and rate them on the same scale you use elsewhere. The rating highlights where to slow down, add protection or bring in a second person. It keeps the job plan tied to real hazards rather than habit. 

### How do likelihood and impact combine into one number? 

Likelihood times impact gives the risk score for a task, and the product reflects both factors at once. A high likelihood with low impact stays moderate, while high likelihood with high impact rises sharply. Score both factors on the same agreed scale so the product stays comparable across tasks. Write down each factor next to the product to keep the reasoning visible. 

### Does a high risk score mean the task cannot be done? 

No, a high risk score marks a task that needs stronger controls, not one to skip. Use the score to set risk priority, then add protection, split the step or assign it to someone trained for it. Some steps need a trained specialist, and the score helps you spot those before work starts. After controls are in place, rescore the task to confirm the level dropped.
