Internal Safety Audit Program
Learn how an internal safety audit program runs: the audit procedure, audit frequency, auditor training, corrective actions and management review steps.
Contents
- What the audit procedure contains
- Choosing audit frequency and scope
- From findings to corrective actions
- Questions about internal safety audits
- Who should carry out the internal safety audit?
- How often should the internal safety audit program run?
- What is the difference between an audit and an inspection?
- What happens after the audit report is issued?
An internal safety audit program is a planned set of checks a business runs on itself to confirm that its safety management system works as written. The program sets out the audit procedure, how often audits happen, who carries them out and how findings turn into corrective actions. This page explains each part in plain terms so you can build or tighten your own program.
What the audit procedure contains
An audit procedure is the written method that tells an auditor what to check and how to record it. It lists the scope of each audit, the evidence to collect and the way findings are graded by severity. A clear procedure also names who receives the report and where the records are kept. Written steps keep audits consistent from one auditor to the next.
Choosing audit frequency and scope
Audit frequency depends on the risk of each area, the size of the operation and the results of earlier audits. A workshop may audit high-risk tasks such as chemical handling more often than office areas. Scheduling every area at least once in a cycle keeps the whole safety management system covered. The program should state what triggers an extra audit, such as an incident or a major change in process.
From findings to corrective actions
Corrective actions close the gap between what the procedure requires and what the audit found. Each finding needs an owner, a defined fix and a date for checking the fix worked. Management review then looks at open and closed actions together to judge whether the safety management system is working. Without a review step, findings repeat across audit cycles.
Questions about internal safety audits
Who should carry out the internal safety audit?
A trained auditor who is independent of the area being audited should carry out the internal audit. Auditor training covers the audit procedure, evidence gathering and how to write findings that others can act on. Someone who works in the audited area can answer questions but should not grade their own work.
How often should the internal safety audit program run?
The frequency of an internal safety audit program depends on the risk of the tasks, the size of the operation and past findings. High-risk areas often need more frequent audits than low-risk ones, and every area should be covered within a set cycle. Any incident or significant process change can justify an unscheduled audit.
What is the difference between an audit and an inspection?
An audit checks whether the safety management system meets its own written requirements, while an inspection looks at physical conditions at a point in time. An audit examines records, procedures and practice together and follows the audit procedure step by step. An inspection can be quick and focused on one piece of equipment or one area.
What happens after the audit report is issued?
Corrective actions are assigned after the audit report is issued, each with an owner and a target date. The program tracks these actions until evidence shows the problem is fixed. Management review then examines the results and decides whether the safety management system or the audit schedule needs to change.