How to Set Up a PF22 2 Foam Cannon

Step through assembling a PF22 foam cannon, connecting it to a pressure washer, attaching the foam bottle and checking the setup before you start washing.

3 min read0 views
— · 0 votes
Contents
  1. Assemble the cannon and nozzle
  2. Attach the foam bottle
  3. Connect to the pressure washer
  4. PF22 foam cannon setup questions
  5. How do I set up a PF22 2 foam cannon?
  6. What pressure washer fitting does it need?
  7. Why does foam come out watery after setup?
  8. Can I leave foam in the bottle after washing?

Setting up a PF22 2 foam cannon means assembling the cannon body and nozzle, attaching the foam bottle, then connecting the unit to a pressure washer and checking the spray before you begin. The page walks through each assembly step in order and explains how the pressure washer connection, the foam bottle attachment and the nozzle settings work together. A few minutes of careful setup keeps the cannon sealed and ready for an even foam layer.

Assemble the cannon and nozzle

Assembling the PF22 foam cannon starts by fitting the nozzle and the suction tube into the cannon body. Thread the nozzle onto the front of the body by hand until it seats, then confirm the connector is snug without over-tightening. Push the suction tube onto the inner pickup point so it reaches the bottom of the bottle once attached. Keep the assembly clean, because grit trapped at the nozzle alters the foam pattern.

Attach the foam bottle

The foam bottle attachment screws onto the lower body of the cannon and seals with the supplied gasket. Turn the bottle clockwise until it stops, then check that the gasket sits flat and the threads are free of grit. A bottle that wobbles or weeps means the gasket is misaligned or the threads need cleaning. Fill the bottle only to its marked line so the suction tube draws foam mix rather than air.

Connect to the pressure washer

The pressure washer connection uses the quick-connect coupler at the inlet of the cannon, which must match the fitting on your wand or hose. Push the coupler onto the fitting until it locks, then pull gently to confirm it holds. Start the pressure washer with the cannon trigger open and let water flow for a moment to clear air. Check every joint for leaks before you add foam mix to the bottle.

PF22 foam cannon setup questions

How do I set up a PF22 2 foam cannon?

A PF22 2 foam cannon is set up by assembling the nozzle and suction tube, attaching the foam bottle, then locking the quick-connect coupler onto the pressure washer wand. Each step is done by hand, with gaskets checked for alignment and threads kept clean. Finish by running water through the cannon to confirm the joints seal before adding foam mix.

What pressure washer fitting does it need?

A PF22 foam cannon needs a quick-connect fitting on the wand or hose that matches the coupler supplied with the cannon. The fitting type depends on the pressure washer brand and model, so check the coupler against your wand before you buy an adapter. An adapter that does not lock fully will leak or blow off under pressure.

Why does foam come out watery after setup?

Foam comes out watery after setup when the suction tube is loose, the bottle is overfilled or the nozzle setting is too open. A tube that sits above the liquid draws air instead of foam mix and thins the output. Push the tube fully onto its pickup point and fill the bottle only to the marked line before adjusting the nozzle.

Can I leave foam in the bottle after washing?

Foam mix should not be left in the PF22 bottle after washing, because the chemicals can settle and clog the suction tube. Empty the bottle, then rinse it and the cannon with clean water by running the pressure washer for a short pass. Store the cannon with the bottle removed so the gasket can dry and the threads stay clean.

Read next

Latest articles