# How to Make a Drawer Inside a Drawer

A practical guide to building a nested drawer: measuring the cavity, sizing the drawer box, fitting slides, and choosing a tray or front that pulls out.

Making a drawer inside a drawer means building a smaller drawer box that travels on its own slides inside an existing cabinet drawer. You measure the interior cavity, size the new box to clear the sides and the drawer front, mount slides or let it run as a sliding tray, and fit a front or pull so it opens without snagging. The result is a nested drawer that adds a second layer of storage to a detailing cart or cabinet without taking up more floor space. 

## Measure the cavity before you cut 

Measure the inside width, depth, and height of the existing drawer at several points, because drawer boxes are often not square. Subtract the thickness of the slides on each side to get the outside size of the new drawer box. Allow clearance at the back for the slide travel and at the front so the nested drawer clears the original drawer front. Write the figures down and cut the drawer box parts to those numbers rather than to the nominal drawer size. 

## Build the drawer box square 

Cut the drawer box sides, front, and back from a stable panel and join them with glue and fasteners suited to the material. Check the diagonals of the assembled box and adjust the clamps until they match, so the box runs true in its slides. A square drawer box keeps the slides parallel and stops the nested drawer from binding as it moves. Fit the bottom last, seated in a groove or under a rabbet, and test the dry box in the cavity before finishing. 

## Mount slides and add a front 

Drawer slides carry the nested drawer and must be fixed to both the original drawer and the new box with screws into solid material. Set the slides level and parallel, then slide the drawer box in and out to check for rubbing on the cabinet drawer sides. Fit a small drawer front or a pull that clears the original drawer front when both are closed. Label the nested drawer so the contents stay obvious when the outer drawer is open. 

## Nested Drawer Build Questions 

### Can I add a sliding tray instead of a full drawer box? 

Yes, a sliding tray works when the nested space is shallow and you only need a single layer of small items. A tray is a shallow open box that runs on short slides or on runners fixed to the original drawer sides. A full drawer box with its own front suits deeper storage and heavier contents. The choice depends on the height of the cavity and the weight you plan to carry. 

### What clearance do drawer slides need inside a drawer? 

Clearance depends on the slide type, and you should read the slide specifications before cutting the drawer box. Each slide needs room on its side plus space at the back for its travel. Measure the actual slide you plan to use, then subtract that figure from the interior width. Leaving too little clearance causes rubbing, and too much lets the nested drawer shift. 

### How do I keep the nested drawer from hitting the outer drawer front? 

The nested drawer clears the outer front when you set the slides back and size the box to stop behind it. Mount the slides so the new box sits behind the original drawer front, and check the closed position before you drill. A small stop block fixed to the original drawer limits how far the nested drawer travels. Test the full travel with the outer drawer open and closed. 

### Do I need a specialist to fit drawer slides? 

No, fitting slides into a wooden drawer is a task you can do with basic tools if the drawer box is square and the measurements are accurate. A trained cabinetmaker is the right person for work on metal drawer systems, damaged cabinet hardware, or any drawer that carries heavy loads. Stop and get help if the original drawer structure is weak or cracked. Solid fixing points matter more than the slide type you choose.
