How to Hang a Pressure Washer Hose
Learn how to hang a pressure washer hose so it drains, coils without kinks and stays off the floor, with hose hanger, bracket and loop hanging tips.
Contents
- Choose a hose hanger or wall hook
- Drain and straighten before hanging
- Coil in loose loops for support
- Pressure Washer Hose Hanging Questions
- Can I hang a pressure washer hose on a single wall hook?
- Should the pressure washer hose be dry before storage?
- How do I stop the hose from kinking when it hangs?
- Where should I mount a hose support bracket in the garage?
Hanging a pressure washer hose keeps the coil off the floor and lets trapped water drain out between jobs. You hang a pressure washer hose by coiling it in loose loops and resting the loops on a hose hanger or wall hook fixed to a solid surface. The hose should be empty, straight and supported along each loop rather than pinched over a single point. A hose support bracket spreads the load when the coil is heavy.
Choose a hose hanger or wall hook
A hose hanger or wall hook carries the coil and keeps it clear of the floor and traffic. Pick a bracket wide enough that the loops open rather than crush together on a narrow peg. Mount it to a solid stud or masonry fixing rated for the weight of a wet hose. A garage wall storage spot away from doors and vehicle paths works well.
Drain and straighten before hanging
Water left inside a pressure washer hose adds weight and can sit in the coil for a long time. Shut off the supply, release the trigger to bleed pressure and run the pump briefly to push water out. Stretch the hose on the ground and remove twists before you lift it. A dry, straight hose coils evenly and drains fully.
Coil in loose loops for support
Loop hanging means forming wide, even circles that rest on the hanger instead of tight wraps around a peg. Keep each loop open and let the hose cross itself as little as possible. Hang the coil so both ends point down and any remaining water can escape. Loose loops protect the inner lining and the outer cover from sharp bends.
Pressure Washer Hose Hanging Questions
Can I hang a pressure washer hose on a single wall hook?
A single wall hook can hold a pressure washer hose, but the coil hangs from one narrow point and can kink there. A wide hose hanger or hose support bracket spreads the load across the loops instead. If you use a single hook, keep the loops large and check the hose for a crease. Never let the full weight of a wet hose pull on the fittings.
Should the pressure washer hose be dry before storage?
The pressure washer hose should be drained before it is hung, because trapped water adds weight and can stagnate in the coil. Release the pressure, disconnect the supply and let the hose empty from its lowest end. Hanging the coil with both ends down lets the last water escape. A dry hose also coils more neatly and is less likely to grow residue inside.
How do I stop the hose from kinking when it hangs?
Kinks form when a pressure washer hose is wrapped tight or bent sharply over a small hook. Coil it in wide loops and hang the loops on a hose hanger that matches their width. Straighten twists on the ground first so the coil does not store a spiral. Check the hanging hose now and then and re-coil any loop that has closed up.
Where should I mount a hose support bracket in the garage?
Mount a hose support bracket on a solid wall in the garage, clear of doors, walkways and vehicle paths. Fix it into a stud or a masonry anchor rated for the weight of a wet hose and hanger. Keep the coil low enough to lift comfortably and high enough to stay off the floor. A spot near the pressure washer shortens the run of hose left lying out.