Convert psi to bar: formula, conversion factor, chart and calculator
Learn how to convert psi to bar with the formula and conversion factor, read a chart for gauge readings, and apply it to pressure washer ratings.
Contents
Converting psi to bar means multiplying a pressure in pounds per square inch by 0.0689476, the conversion factor that turns psi into the bar pressure unit. This page gives the psi to bar formula, a psi to bar conversion chart, and guidance for reading pressure washer PSI and bar ratings. You can use the numbers here as a handheld calculator for detailing equipment settings.
The psi to bar formula
The psi to bar conversion formula multiplies the psi value by 0.0689476 to give the pressure in bar. One psi equals about 0.0689476 bar, and the exact factor is 0.0689475729 bar per psi. To go the other way, bar to psi conversion divides by that factor, which is the same as multiplying by about 14.5038. Round the result to the precision your pressure gauge can actually show.
Reading a conversion chart
A psi to bar conversion chart pairs gauge readings so you can skip the arithmetic at the machine. The same chart works for air compressor tank pressure and for a pressure washer PSI rating, since both describe force per area. A psi to bar conversion table lists psi down one side and the matching bar value beside it. Keep a printed psi to bar conversion chart pdf with the equipment so the numbers are on hand.
Pressure washer PSI and bar
A pressure washer PSI rating and its bar rating describe the same output in different pressure units. Pressure washer PSI to bar conversion uses the same 0.0689476 factor, so a rating in psi becomes a bar figure you can compare with the machine label. Detailing equipment pressure settings often appear in bar on a gauge and in psi in a spec sheet. Match the units before you set a nozzle or adjust the regulator.
psi to bar questions
How do I convert psi to bar?
To convert psi to bar, multiply the psi figure by 0.0689476, the psi to bar conversion factor. A reading of 100 psi becomes about 6.89 bar with that formula. Use the same factor for any pressure value, then round to suit your gauge.
What is the conversion factor from psi to bar?
The psi to bar conversion factor is 0.0689476, and the fuller value is 0.0689475729 bar per psi. This factor comes from the definition of pounds per square inch against the bar pressure unit. Dividing a bar value by the factor converts it back to psi.
Is there a psi to bar conversion calculator or chart?
Yes, a psi to bar conversion calculator applies the factor for you, and a psi to bar conversion chart does the same on paper. A psi to bar conversion table or a psi to bar conversion chart pdf is handy beside a pressure gauge. Enter the psi value and read the matching bar figure.
How do I convert pressure washer PSI to bar?
Pressure washer PSI to bar conversion uses the same factor of 0.0689476. Multiply the pressure washer PSI rating by that number to get the bar figure. Check both units against the machine label before you set detailing equipment pressure settings.