# Build DIY Shelving in a Mobile Detailing Van

Plan, build and install plywood van shelving for a mobile detailing rig, with mounting tips, load limits and a storage layout for your detailing supplies.

Building DIY shelving in a mobile detailing van means planning a layout and fixing shelves to structural points. The page covers shelf materials, shelf mounting in a cargo van, and how to respect your van payload. Van payload is the total weight the vehicle can carry, including racks, tools, water and chemicals. A homemade van shelving system can match your detailing workflow more closely than a generic kit. 

## Plan the detailing van storage layout 

A mobile detailing van storage layout starts with the tools you reach for on every job. Keep heavy items such as the water tank and pressure washer low, close to the rear axle. Light bottles, towels and brushes go on upper shelves along the side wall, near the sliding door. Van racking plans should show measured rib positions before you buy any shelf materials. 

## Choose shelf materials and build the frame 

Plywood van shelving uses plywood decks supported by aluminum angle brackets or a timber frame. Plywood is light for its strength, and aluminum angle adds stiffness without much extra weight. Seal the plywood with a finish, since spilled chemicals and wet towels can swell bare wood. Add a raised front lip or cargo bar to each shelf to restrain bottles during braking. 

## Mount shelving to the van structure 

Cargo van shelving installation relies on the floor and wall anchor points built into the body. Bolt uprights to steel ribs or factory threaded holes, never to the thin outer skin alone. Before drilling, check behind each panel for wiring, fuel lines and brake lines. If you are unsure about the structure, have a trained van upfitter do the mounting. 

## Questions about DIY detailing van shelving 

### How do you install American Van shelving in a cargo van? 

American Van shelving mounts by fastening the units to the van floor and wall structure. The hardware and hole positions depend on the shelving model for your specific van. Follow the maker's instructions for the torque and fastener type on each mounting point. 

### How much weight can DIY van shelves hold? 

DIY van shelves hold only as much as their weakest part, whether shelf, bracket or fastener. A homemade build lacks a load rating, the tested weight limit a manufacturer publishes. Count the weight of shelves and full bottles against the van payload in the manufacturer's specifications. 

### Can I use the same plans for DIY truck shelving? 

Yes, the same plywood and bracket approach works for truck shelving inside a cap or box body. Truck beds and caps have different anchor points, so measure the mounting surfaces again. Moisture can reach shelving under a truck cap, so choose sealed plywood or aluminum. 

### Are wall rails better than fixed shelf brackets in a van? 

Wall rails are the more flexible choice, since shelf brackets slide to new heights as your kit changes. Fixed shelf brackets take fewer parts and keep a DIY shelf build simple. Wall-mounted van racks on rails still need bolting to ribs or anchor points at intervals along their length.
